The TrackMount is a holder that secures a Bluetooth tracker to your cane or other cylindrical mobility aid. No elastic bands, no adhesives, no clips that fall off.
Instead of stretching or sticking, the TrackMount threads together mechanically. The cap tightens down against the cane shaft until snug, so it holds firm without anything to wear out, peel off, or loosen in the cold.
When every step matters, now a misplaced cane is a phone tap away from being found.
WHAT'S IN THE SET
Every TrackMount set comes with four parts: a Main Body, a Main Cap, a Perforated Cap, and an O-ring.
Works with AirTag, AirTag 2, Tile Sticker, Moto Tag, and Moto Tag 2.
MAIN BODY
The core of the TrackMount. Slides onto your cane through a lateral opening and houses the tracker compartment.
MAIN CAP
Threads onto the Main Body and tightens against your cane to lock the device in place. Tighten until snug.
PERFORATED CAP
Threads onto the tracker compartment. Open holes allow your tracker's audible alerts to pass through clearly, so you can hear your cane as well as see it on your phone.
O-RING
Sits in the tracker compartment and cushions your tracker, so it stays quiet and secure instead of rattling as you walk. It comes already installed.
TWO SIZES
The TrackMount fits cane shafts 7/8" in diameter (standard aluminum canes). The TrackMount XL fits shafts 1" in diameter (Heavy duty aluminum canes and wooden canes).
See our Sizing Guide to confirm which one matches your cane.
INSTALLATION
Installation takes about a minute and requires no tools. How you position your tracker depends on which one you have, so see our Installation page for step-by-step instructions and a video walkthrough.
