Watch the video above, or follow the written steps below. Installation takes about a minute and requires no tools.
Click Here for Printable Instructions
Step 1 — Install Your Tracker
Every TrackMount comes with an O-ring already installed in the tracker compartment. The O-ring cushions your tracker so it doesn't rattle inside the mount as you walk.
How you place the tracker depends on which one you have.
AirTag and AirTag 2
Place the tracker on top of the O-ring, then thread on the Perforated Cap and tighten until secure.
Moto Tag and Moto Tag 2
Place the tracker on top of the O-ring with the button side facing down. This keeps the cap from pressing the button when you tighten it. Then thread on the Perforated Cap and tighten until secure.
Tile Sticker
The Tile Sticker sits inside the O-ring rather than on top of it.
- Lift the O-ring out of the compartment
- Place the Tile Sticker in the bottom of the compartment
- Set the O-ring back in, resting on top of the tracker
- Thread on the Perforated Cap and tighten until secure
Step 2 — Install the TrackMount on Your Cane
- Slide the TrackMount onto your cane through the lateral opening
- Position it just below the handle, aligned with the cane's handle and facing the same direction
- Thread on the Main Cap and tighten until snug
That's it. Your tracker is mounted, protected, and ready to help you find your cane wherever it goes.
Removing or Moving Your TrackMount
Unthread the Main Cap and slide the TrackMount off through the lateral opening. It can be moved to another cane of the same diameter at any time.
Questions? Email contact@trackmounts.com
